Spent a couple of hours tonight deburring parts for the Vertical Stabilizer. I started with the ribs and focused first on VS-705 which had been scratched from the press. This took the longest time as I tried to completely remove any trace of the scratches. It came out looking good, as did the other pieces. My main tools were scotchbrite pads, and the scotchbrite wheel on my bench grinder. I also used a small flat file in a couple of hard to reach spots. Hoping to get the spare done tomorrow night, and then the skin, so I can start priming all of these parts. Tonight’s effort seemed very time consuming, but this is due mostly to the scratch removal needed on the ribs, which shouldn’t be a problem with the spas and skin, which don’t (currently) have scratches.
The same piece before deburring:
