Tonight I pop riveted on the rod ends for the longer two aileron pushrods, and cut and drilled pilot holes for the shorter two. I also primed the threads of the rod ends for the longer pushrods. I didn’t get started until 10:30pm, as I’m quite busy at work this week.
Pop riveting the ends was straightforward. I needed to sand down the primer inside the tubes for two of the 4 ends, but they eventually all fit nicely.
With that done, I cut the two shorter pushrods from the supplied powder-coated steel rods. Then I marked and drilled the holes for the rod ends on these shorter two rods. I was getting quite tired, so I decided to finish by priming the threads on the rod ends.
