Today I installed the LED light strip on the glare shield. I bought a cheap red LED light strip from Amazon, so I’m not sure how well the strip will hold up in the long term. To make replacement easy I installed some d-sub pins and left a service loop held down by the Velcro.
Before I installed the light strip I tested the lights to make sure they worked with a 9V battery, then cut the light strip to size.
The glare shield has a great insert for the light strip, and I had this wrapped up in no time.
I struggled to get a neat-enough looking wiring installation. My service loop for the fans adds extra wiring that needs to be held in place. I used a decent amount of spiral wrap to prevent wires from chaffing on the shop heads of the rivets. the result was ok, but not as tidy as I had hoped.
