Tonight I made and installed a ground point for the instrument panel ground leads, and wired up the FlyLED “The Works” controller board.
The ground point is on the sub structure between the firewall and the instrument panel. Since the rib in that area is thin, I installed a plate on each side of the rib, secured with rivets in each corner. Before installing I removed the primer from both sides of the rib. Tomorrow I should be getting a bolt in the mail which will fit nicely here, securing the ground wires. This was the first time I needed to go on my back, up under the panel. It sucked. I removed the passenger side stick and used a cushion, but it was still very cramped and uncomfortable.
With that job done, I wired up the FlyLED controller board. I’ll need to mount this behind the panel somewhere, so I’ll be doing more crawling under the panel to install I’m sure.
