Today we continued working on the cowling and the exhaust system.
While Dad handled the sanding and fitting of the cowling, I worked on setting up the exhaust system. First I assembled the support clamps, then applied anti-seize lubricant to the sleeve and ball fittings, then set it up underneath the engine.
With dad’s help we were able to mount the pipes onto the cylinders, doing up the hardware finger tight.
Using a roll of 3/4 inch electrical tape, I set the spacing correctly and installed the support clamps on the aft edge.
Dad did another round of filling today, as there is still a ways to go to achieve the alignment we need on the cowling air inlets. It’s amazing to watch him work, knowing just what’s needed to get the perfect fit and finish. At 79 years old he’s still putting in very long days, with no complaints.