Oil cooler

After a 10 day work trip to India I was able to accomplish one small task tonight. I cut and deburred these spacers for the oil cooler. Right now this is about all I’m going to do with the oil cooler. I’m hoping to pick up a 3D printed oil cooler plenum to replace the standard Vans model. The 3D printed plenum will be circular to match the circular scat tube, vs. the square cornered Vans model. Based on what I’ve read and been told, there should be some improvement in oil cooling efficiency using this modified plenum. It’s currently in testing and not ready for production, but hopefully will be ready near the end of the year.

I also took a few minutes to confirm that my oil cooler serial number is not in the range impacted by the service bulletin issued earlier this year. https://www.vansaircraft.com/service-information-and-revisions/sb-00080-rev-2/

Oil cooler spacers

Leave a Reply

Your email address will not be published. Required fields are marked *